The Eugene Bend knot is started in the same manner whether or not you are using a set of forceps to assist with tying the knot. Start the Eugene Bend knot by running the tippet end through the hook eye and back up the line. Form a second loop in the opposite direction with the tag. Hold the tag end and the hook eye between your fingers (Fig. 1).

Eugene Bend Knot Figure 1

Insert a closed pair of forceps through the second loop and rotate the closed ends of the forceps around the standing line three times. This automatically also wraps the second loop around the standing line three times (Fig.2).

Eugene Bend Knot Figure 2

Now grasp the tag end of the tippet with the forceps and pull the forceps out of the second loop thereby pulling the tag end of the tippet through the second loop (Fig. 3).

Eugene Bend Knot Figure 3

Pull the tag end until the end loops of the knot are small enough that they cannot slip over the hook eye. The knot should be snug, but not tight, and should be located several inches above the hook eye (Fig. 4).

Eugene Bend Knot Figure 4

Wet the knot to lubricate it and protect the monofilament from frictional heat damage. Then with a smooth steady motion, pull the standing line until the knot slides down the standing line to the hook eye and seats. You will know the knot is properly seated when you hear and feel the knot click into position. In addition, a properly tied and seated Eugene Bend knot will have the tag end forming a very pronounced V with the standing line (Fig.5).

Eugene Bend Knot Figure 5

What Works Best With A Eugene Bend Knot?

The Eugene Bend knot works best with monofilament lines of about 12 pounds breaking strength or less. It also works better with soft lines than with hard stiff lines.

By using a pair of forceps (hemostats) to assist with tying the knot you will find changing flies with very light tippet and tying with wet hands to be far easier and the cause of many fewer impolite words on stream.